Search results
Results from the WOW.Com Content Network
More water is therefore used than is chemically and physically necessary to react with cement. Water–cement ratios in the range of 0.40 to 0.60 are typically used. For higher-strength concrete, lower w/c ratios are necessary, along with a plasticizer to increase flowability.
Saturated unit weight The unit weight of a soil when all void spaces of the soil are completely filled with water, with no air. The formula for saturated unit weight is: = (+) + where γ s is the saturated unit weight of the material; γ w is the unit weight of water; G s is the specific gravity of the solid; e is the void ratio [3] Submerged ...
The ultimate strength of concrete is influenced by the water-cementitious ratio (w/cm), the design constituents, and the mixing, placement and curing methods employed.All things being equal, concrete with a lower water-cement (cementitious) ratio makes a stronger concrete than that with a higher ratio. [2]
Materials such as stones, sand and ceramics are considered 'dry' and have much lower equilibrium moisture content than organic material like wood and leather. [7] typically a fraction of a percent by weight when in equilibrium of air of Relative humidity 10% to 90%. This affects the rate that buildings need to dry out after construction ...
K D = around 10 for artificial interlocking concrete blocks; S r = (ρ r / ρ w is the relative density of rock, i.e. (ρ r / ρ w - 1) = around 1.58 for granite in sea water; ρ r and ρ w are the densities of rock and (sea)water (-) θ is the angle of revetment with the horizontal
Changes of pore water content due to drying or wetting processes cause significant volume changes of concrete in load-free specimens. They are called the shrinkage (typically causing strains between 0.0002 and 0.0005, and in low strength concretes even 0.0012) or swelling (< 0.00005 in normal concretes, < 0.00020 in high strength concretes).
γ′ is the effective unit weight when saturated or the total unit weight when not fully saturated. B is the width or the diameter of the foundation. φ′ is the effective internal angle of friction. K pγ is obtained graphically. Simplifications have been made to eliminate the need for K pγ. One such was done by Coduto, given below, and it ...
Abrams' law (also called Abrams' water-cement ratio law) [1] is a concept in civil engineering. The law states the strength of a concrete mix is inversely related to the mass ratio of water to cement. [1] [2] As the water content increases, the strength of concrete decreases. Abrams’ law is a special case of a general rule formulated ...