Search results
Results from the WOW.Com Content Network
This is a USB 3.0 Y-cable. Traditional USB Y-cables exist to enable one USB peripheral device to receive power from two USB host sockets at once, while only transceiving data with one of those sockets. As long as the host has two available USB sockets, this enables a peripheral that requires more power than one USB port can supply (but not more ...
A single Thunderbolt 3 or later port provides data transfer, support for two 4K 60 Hz displays, and quick notebook charging up to 100W with a single cable. Any Thunderbolt or USB dock can connect to a Thunderbolt 3 computer. USB devices can be connected to a Thunderbolt 3 or later port. DisplayPort and Mini DisplayPort devices are supported.
In this way, cables with smaller 5 pin USB 2.0 Micro-B plugs can be plugged into devices with 10 contact USB 3.0 Micro-B receptacles and achieve backward compatibility. USB cables exist with various combinations of plugs on each end of the cable, as displayed below in the USB cables matrix. USB 3.0 Standard-B plug
Apple Lightning to USB-A cable. Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [24] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.
USB bridge cables, or data transfer cables can be found within the market, offering direct PC to PC connections. A bridge cable is a special cable with a chip and active electronics in the middle of the cable. The chip in the middle of the cable acts as a peripheral to both computers and allows for peer-to-peer communication between the computers.
Under the USB 3.2 specification, released 22 September 2017, [11] existing SuperSpeed certified USB-C 3.1 Gen 1 cables will be able to operate at 10 Gbit/s (up from 5 Gbit/s), and SuperSpeed+ certified USB-C 3.1 Gen 2 cables will be able to operate at 20 Gbit/s (up from 10 Gbit/s). The increase in bandwidth is a result of multi-lane operation ...
IEEE 1394 is an interface standard for a serial bus for high-speed communications and isochronous real-time data transfer. It was developed in the late 1980s and early 1990s by Apple in cooperation with a number of companies, primarily Sony and Panasonic.
USB On-The-Go (USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mice or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the roles ...