Search results
Results from the WOW.Com Content Network
A fuel control unit attempts to solve those problems by acting as an intermediary between the operator's controls and the fuel valve. The operator has a power lever which only controls the engine's potential, not the actual fuel flow. The fuel control unit acts as a computer to determine the amount of fuel needed to deliver the power requested ...
A compressor stall is a local disruption of the airflow in the compressor of a gas turbine or turbocharger. A stall that results in the complete disruption of the airflow through the compressor is referred to as a compressor surge. The severity of the phenomenon ranges from a momentary power drop barely registered by the engine instruments to a ...
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
A free-turbine turboshaft ingests air through an intake. The air passes through a compressor and into a combustor where fuel is mixed with the compressed air and ignited. The combustion gases are expanded through a compressor-driving turbine, and then through a "free" power turbine before being exhausted to the atmosphere.
The next two runs with the new pump were a great disappointment; the instruments showed no significant flow or pressure rise. The problem was traced to the exit diffuser of the pump, which was too small and insufficiently cooled during the cool-down cycle so that it limited the flow. This was corrected by adding vent holes in the pump housing ...
Since the electric pump does not require mechanical power from the engine, it is feasible to locate the pump anywhere between the engine and the fuel tank. The reasons that the fuel pump is typically located in the fuel tank are: By submerging the pump in fuel at the bottom of the tank, the pump is cooled by the surrounding fuel; Liquid fuel by ...
Accessory Gearbox – bevel gears that extract 35 to 100 hp (26 to 75 kW) from the high-pressure spool to operate the fuel control unit, starter, oil pump, and vehicle hydraulic pump; Power Turbines – the first stage of the two-stage power turbine is driven by a variable-geometry nozzle to improve efficiency; Reduction Gearbox – reduces ...
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...