Search results
Results from the WOW.Com Content Network
The fixed pulley on the upper shaft is driven at constant speed by a belt from the power source. The loose pulley ('idler') allows the machine to be stopped in isolation – necessary for changing speed. The stepped pulleys (left) provide three drive speeds for the machine tool (not shown), depending on which pair of pulleys is connected by the ...
Belts are looped over pulleys and may have a twist between the pulleys, and the shafts need not be parallel. In a two pulley system, the belt can either drive the pulleys normally in one direction (the same if on parallel shafts), or the belt may be crossed, so that the direction of the driven shaft is reversed (the opposite direction to the ...
A pulley is a wheel on an axle or shaft enabling a taut cable or belt passing over the wheel to move and change direction, or transfer power between itself and a shaft. A sheave or pulley wheel is a pulley using an axle supported by a frame or shell ( block ) to guide a cable or exert force.
A dumb pulley can lift very large masses a short distance. It consists of two fixed pulleys of unequal radii that are attached to each other and rotate together, a single pulley bearing the load, and an endless rope looped around the pulleys. To avoid slippage, the rope is usually replaced by a chain, and the connected pulleys by sprockets.
Pulleys are made up of several components including the shell, end disk, hub, shaft and locking assembly. The end disk and hub may be one piece. The locking assembly may also be replaced with a hub and bushing on lower tension pulleys. The shell is also referred to as the rim in some parts of the world.
AOL latest headlines, entertainment, sports, articles for business, health and world news.
The following stresses are induced in the shafts.. Shear stresses due to the transmission of torque (due to torsional load).; Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft.
Stock removal is the process of removing material (stock) from a workpiece. Stock removal processes include: [1] Machining; Milling; Turning; Drilling; Grinding; Filing;