Search results
Results from the WOW.Com Content Network
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
A nautical mile is a unit of length used in air, marine, and space navigation, and for the definition of territorial waters. [2] [3] [4] Historically, it was defined as the meridian arc length corresponding to one minute ( 1 / 60 of a degree) of latitude at the equator, so that Earth's polar circumference is very near to 21,600 nautical miles (that is 60 minutes × 360 degrees).
The charts are published "in accordance with Interagency Air Cartographic Committee specifications and agreements, approved by the Department of Defense and the Federal Aviation Administration". The legend of an aeronautical chart lists many of the symbols, colors and codes used to convey information to the map reader.
Geographical distance or geodetic distance is the distance measured along the surface of the Earth, or the shortest arch length.. The formulae in this article calculate distances between points which are defined by geographical coordinates in terms of latitude and longitude.
A World Aeronautical Chart (WAC) was a type of aeronautical chart used for navigation by pilots of moderate speed aircraft and aircraft at high altitudes in the United States. They are at a scale of 1:1,000,000 (about 1 inch = 13.7 nautical miles or 16 statute miles).
State legislation in the US is important for determining which conversion factor from the metric datum is to be used for land surveying and real estate transactions, even though the difference (2 ppm) is hardly significant, given the precision of normal surveying measurements over short distances (usually much less than a mile). Twenty-four ...
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
Intermediate fields were located every 30 miles (48 km) in case of emergencies, with at least two landing strips a minimum of 2,000 feet (610 m) in length, and 600 feet (180 m) in width. Rotating airways beacons were erected every 10 miles (16 km). [ 7 ]