enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The Jacobs Taper (abbreviated JT) is commonly used to secure drill press chucks to an arbor. The taper angles are not consistent varying from 1.41° per side for No. 0 (and the obscure # 2 + 1 ⁄ 2) to 2.33° per side for No. 2 (and No. 2 short). There are also several sizes between No. 2 and No. 3: No. 2 short, No. 6 and No. 33.

4. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

5. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   The series number is the opening diameter of the tapered receptacle, in millimetres. ER collets collapse to hold parts up to 1 mm smaller than the nominal collet internal size in most of the series (up to 2 mm smaller in ER-50, and 0.5 mm in smaller sizes) and are available in 1 mm or 0.5 mm steps.

6. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8-16 tap, the above formula would produce 5 ⁄ 16, which is the correct tap drill diameter. The above formula ultimately results in an approximate 75% thread.

7. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .