Search results
Results from the WOW.Com Content Network
Other applications include antenna testing, frequency stability and frequency accuracy checking. Usually a WSPR station contains a computer and a transceiver, but it is also possible to build very simple beacon transmitters with little effort. For example a simple WSPR beacon can be built using the Si 570, [5] or Si 5351. [6]
A waterfall display showing FT8 in use on the 40-meter band.. FT8 (short for Franke-Taylor design, 8-FSK modulation) is a frequency shift keying digital mode of radio communication used by amateur radio operators worldwide.
The Precision Time Protocol (PTP) is a protocol for clock synchronization throughout a computer network with relatively high precision and therefore potentially high accuracy. . In a local area network (LAN), accuracy can be sub-microsecond – making it suitable for measurement and control systems.
A real-time clock (RTC) is an electronic device (most often in the form of an integrated circuit) that measures the passage of time. Although the term often refers to the devices in personal computers, servers and embedded systems, RTCs are present in almost any electronic device which needs to keep accurate time of day.
The PTP Industrial Profile (PIP) is a standard of the IEC 62439-3 [1] that specifies in its Annex C two Precision Time Protocol IEEE 1588 / IEC 61588 profiles, L3E2E and L2P2P, to synchronize network clocks with an accuracy of 1 μs and provide fault-tolerance against clock failures.
The documentation of Red Hat MRG version 2 states that TSC is the preferred clock source due to its much lower overhead, but it uses HPET as a fallback. A benchmark in that environment for 10 million event counts found that TSC took about 0.6 seconds, HPET took slightly over 12 seconds, and ACPI Power Management Timer took around 24 seconds.
In a one-way time transfer system, one end transmits its current time over some communication channel to one or more receivers. [4]: 116 The receivers will, at reception, decode the message, and either just report the time, or adjust a local clock which can provide hold-over time reports in between the reception of messages.
Telecommunication networks rely on the use of highly accurate primary reference clocks which are distributed network-wide using synchronization links and synchronization supply units. Ideally, clocks in a telecommunications network are synchronous, controlled to run at identical rates, or at the same mean rate with a fixed relative phase ...