enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spark testing - Wikipedia

   en.wikipedia.org/wiki/Spark_testing

   Spark testing also can be used to sort ferrous materials, establishing the difference from one another by noting whether the spark is the same or different. Spark testing is used because it is quick, easy, and inexpensive. Moreover, test samples do not have to be prepared in any way, so, often, a piece of scrap is used.

3. Eddy-current testing - Wikipedia

   en.wikipedia.org/wiki/Eddy-current_testing

   Variations in the electrical conductivity and magnetic permeability of the test object, and the presence of defects causes a change in eddy current and a corresponding change in phase and amplitude that can be detected by measuring the impedance changes in the coil, which is a telltale sign of the presence of defects. [5]

4. Growler (electrical device) - Wikipedia

   en.wikipedia.org/wiki/Growler_(electrical_device)

   A growler is an electrical device primarily used for testing a motor for shorted coils. A growler consists of a coil of wire wrapped around an iron core and connected to a source of alternating current. When placed on the armature or stator core of a motor the growler acts as the primary of a transformer and the armature coils act as the ...

5. Safety testing of explosives - Wikipedia

   en.wikipedia.org/wiki/Safety_testing_of_explosives

   The weight is released, impacts upon the sample, and the result is noted. The impact distances are determined and the results are analyzed by the sensitivity test and analysis methods selected. The two most common sensitivity test and analysis methods are the Bruceton analysis and Neyer d-optimal test. These methods allow the user to determine ...

6. Capacitor discharge ignition - Wikipedia

   en.wikipedia.org/wiki/Capacitor_discharge_ignition

   The discharge capacitor within the CD ignition had the ability to provide a powerful spark in excess of 4 times the spark power of the Kettering system using the same coil, with the exception that spark energy could be maintained at high rpm unlike the Kettering system. The Hyland unit consumed only four amperes at 5000rpm (8cyl) or 10,000rpm ...

7. Contact breaker - Wikipedia

   en.wikipedia.org/wiki/Contact_breaker

   The contact breaker is operated by an engine-driven cam.On an engine with a distributor, the contact breaker can be found beneath the distributor cap.The position of the contact breaker is set so that it opens (and hence generates a spark) at exactly the optimum moment to ignite the fuel/air mixture.

8. Magnetic particle inspection - Wikipedia

   en.wikipedia.org/wiki/Magnetic_particle_inspection

   Depending on requirements, the orientation of the magnetic field may need to be changed 90 degrees to inspect for indications that cannot be detected from steps 3 to 5. The most common way to change magnetic field orientation is to use a "coil shot". In Fig 1 a 36-inch coil can be seen then steps 4, 5, and 6 are repeated.

9. Leeb rebound hardness test - Wikipedia

   en.wikipedia.org/wiki/Leeb_rebound_hardness_test

   While in the traditional static tests the test force is applied uniformly with increasing magnitude, dynamic testing methods apply an instantaneous load. A test takes a mere 2 seconds and, using the standard probe D, leaves an indentation of just ~0.5 mm in diameter on steel or steel casting with a Leeb hardness of 600 HLD.