Search results
Results from the WOW.Com Content Network
The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.
A rolling code (or sometimes called a hopping code) is used in keyless entry systems to prevent a simple form of replay attack, where an eavesdropper records the transmission and replays it at a later time to cause the receiver to 'unlock'. Such systems are typical in garage door openers and keyless car entry systems.
The system typically features three buttons, most often found on the driver-side visor or on the overhead console, which can be programmed via a training sequence to replace existing remote controls. It is compatible with most RF-controlled garage door openers, as well as home automation systems such as those based on the X10 protocol.
Chamberlain's "myQ" technology is embedded in garage door openers and lights, [5] can be added to Wi-Fi networks to control these devices and is being incorporated into future home products, all through a monthly subscription. [6]
Another example is an electric kiln. To prevent access to the inside of an electric kiln, a trapped key system may be used to interlock a disconnecting switch and the kiln door. While the switch is turned on, the key is held by the interlock attached to the disconnecting switch. To open the kiln door, the switch is first opened, which releases ...
Swing side, door mounted sensor—mounted on the swing side of the door itself, used as the door is opening to detect a user in the way of the opening door. In that case, the operator stops the door. The sensitivity of infrared sensors must be reduced at the end of the opening angle, if it starts seeing a wall next to the door, so it may not ...
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.
A door closer is a mechanical device that regulates the speed and action of a door’s swing. [1] Manual closers store the force used to open the door in some type of spring and reuse it to close the door. Automatic types use electricity to regulate door swing behavior. Door closers can be linked to a building's fire and security alarm systems. [2]