Search results
Results from the WOW.Com Content Network
IDEX Corporation, based in Northbrook, Illinois, is a publicly traded company engaged in the development, design, and manufacture of fluidics systems, optics systems, fire and rescue equipment, and other specialty engineered products.
Polyether ether ketone (PEEK) is a colourless organic thermoplastic polymer in the polyaryletherketone (PAEK) family, used in engineering applications. It was invented in November 1978 [2] and brought to market in the early 1980s by part of Imperial Chemical Industries (ICI), the PEEK division was acquired through a management buyout, giving rise to Victrex PLC.
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
Fitting being crimped using a specialized tool Pressfittings connection with dead space around the O-ring. Crimped or pressed connections to use special fittings permanently attached to tubing with a powered crimper. The fittings, manufactured with a pre-installed sealant or O-ring, slide over the tubing to be connected. High pressure is used ...
Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler. Couplers use springs and balls to lock mating nipples into place. A seal is effected using O-rings along the shaft of the nipple or by compression by the tip.
The types are named with a full name and an abbreviation, such as NPT, NPS, NPTF, or NPSC. MIP is an abbreviation for male iron pipe, and FIP is an abbreviation for female iron pipe. [2] Outside North America, some US pipe thread sizes are widely used, as well as many British Standard Pipe threads and ISO 7–1, 7–2, 228–1, and 228-2 threads.
The in-line components, known as fittings, [3] valves, and other devices, typically sense and control the pressure, flow rate and temperature of the transmitted fluid, and usually are included in the field of piping design (or piping engineering), though the sensors and automatic controlling devices may alternatively be treated as part of ...
Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.