Search results
Results from the WOW.Com Content Network
Delco ECU used in General Motors vehicles built in 1996. An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
The engine control unit (ECU) of the 14CUX system is run by a Motorola MC6803U4 8-bit microprocessor, which is an uncommon variant of the otherwise ubiquitous 6803. The processor is mislabelled in the ECU, possibly to deter any reverse engineering efforts. The 14CUX determines fueling values for each bank of the V8 separately, which requires ...
What made this ECU special was the use of two crank sensors and one cam sensor. The ECU used one crank sensor to count the teeth on the starter ring for its RPM signal, and the other read a pin on the back of the flywheel for TDC reference. This ECU was first seen when the 20V turbo 5-cylinder engine (RR Code) was installed into the Audi Quattro.
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
Preliminary design work in EEC-IV started even before EEC-III was in production. Over time, there were many different modules designed around this processor. It is likely that more Ford vehicles were produced using Engine/Powertrain Control Modules (ECM/PCM) based on variations of this design than any other module that Ford has ever used.
A Digifant II DF-1 Engine Control Unit used in '91 Volkswagen Golf Cabriolet with 2E engine. Digifant is an Engine Management System operated by an Engine Control Unit that actuates outputs, such as fuel injection and ignition systems, using information derived from sensor inputs, such as engine speed, exhaust oxygen and intake air flow. [1]
SECU-3 project logos SECU-3T revCU6 USB with MAP. SECU-3 [1] is an internal combustion engine control unit.It is being developed as an open source project (drawings, schematic diagrams, source code etc. are open and freely available for all).
The Trionic 8 is an advanced engine management system in the Trionic series, created by Saab Automobile.It is used in both Saab 9-3 and Opel Vectra vehicles, and is available with 150, 175 and 210 horsepower (160 kW) engines.