Search results
Results from the WOW.Com Content Network
Cisco Express Forwarding (CEF) is an advanced layer 3 switching technology used mainly in large core networks or the Internet to enhance the overall network performance. . Although CEF is a Cisco proprietary protocol other vendors of multi-layer switches or high-capacity routers offer a similar functionality where layer-3 switching or routing is done in hardware (in an ASIC) instead of by ...
Static routes, connected routes, and routes from dynamic configuration protocols can be redistributed by dynamic routing protocols. For instance a router may have a static or connected route for a local network segment, which is then redistributed over dynamic routing protocols to enable connectivity to that network.
Example of setting up EIGRP on a Cisco IOS router for a private network. The 0.0.15.255 wildcard in this example indicates a subnetwork with a maximum of 4094 hosts—it is the bitwise complement of the subnet mask 255.255.240.0.
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
DMVPN is initially configured to build out a hub-and-spoke network by statically configuring the hubs (VPN headends) on the spokes, no change in the configuration on the hub is required to accept new spokes. Using this initial hub-and-spoke network, tunnels between spokes can be dynamically built on demand (dynamic-mesh) without additional ...
In link-state routing protocols, each router possesses information about the complete network topology. Each router then independently calculates the best next hop from it for every possible destination in the network using local information of the topology. The collection of best next hops forms the routing table.
To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular destination can be optimally reached by sending the packet to a specific router that represents the next hop on the way to the final destination.
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst