enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Fixed ladder - Wikipedia

    en.wikipedia.org/wiki/Fixed_ladder

    Stand-off brackets: Dictated by OSHA Standard 1910.27(c)(4) stand-off brackets must be at least 7" (180 mm) longer than the farthest obstruction for clearance on the back side of ladder. This means that if there is a 4" (100 mm) gutter projecting from the side of a building, a fixed ladder would have to have standoff brackets that were at least ...

  3. Grab bar - Wikipedia

    en.wikipedia.org/wiki/Grab_bar

    Occupational Safety and Health Administration (OSHA) guidelines describe the requirements for grab bar clearance, diameter and spacing on fixed ladders. [4] These regulations state that the clearance in the back of grab bars must be at least 4 inches, the diameter similar to the ladder rungs and, when horizontal, grab bars must be spaced by a ...

  4. Engineering fit - Wikipedia

    en.wikipedia.org/wiki/Engineering_fit

    Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.

  5. Engineering controls - Wikipedia

    en.wikipedia.org/wiki/Engineering_controls

    The OSHA permissible exposure limit (PEL) is 90 dBA as an 8 hr-TWA, using a 5 dBA exchange rate. [22] The exchange rate means that when the noise level is increased by either 3 dBA (according to the NIOSH REL) or 5 dBA (according to the OSHA PEL), the amount of time a person can be exposed to a certain noise level to receive the same dose is ...

  6. Ladder - Wikipedia

    en.wikipedia.org/wiki/Ladder

    An extension ladder. A ladder is a vertical or inclined set of rungs or steps commonly used for climbing or descending. There are two types: rigid ladders that are self-supporting or that may be leaned against a vertical surface such as a wall, and rollable ladders, such as those made of rope or aluminium, that may be hung from the top.

  7. Handrail - Wikipedia

    en.wikipedia.org/wiki/Handrail

    This was not corrected in 2010 with the approval of the new ADASAD which now calls for a 1 + 1 ⁄ 2 inches (38 mm) minimum clearance. Codes also generally require that there be a 1 + 1 ⁄ 2 inches (38 mm) clearance between the underside of the handrail and any obstruction—including the horizontal bracket arm.

  8. Manual handling of loads - Wikipedia

    en.wikipedia.org/wiki/Manual_handling_of_loads

    In the United States, Occupational Safety and Health Administration (OSHA) is the governing body which regulates workplace safety. OSHA does not have a standard which sets a maximum allowable weight that employers must follow. [19] However, manual materials handling may fall under Section 5(a) which is often referred to as the General Duty ...

  9. Job safety analysis - Wikipedia

    en.wikipedia.org/wiki/Job_safety_analysis

    The terms "job" and "task" are commonly used interchangeably to mean a specific work assignment. Examples of work assignments include "operating a grinder," "using a pressurized water extinguisher" or "changing a flat tire." Each of these tasks have different safety hazards that can be highlighted and fixed by using the job safety analysis.