Search results
Results from the WOW.Com Content Network
The manual throttle may also be considered a flight control because it is needed to maintain rotor speed on smaller helicopters without governors. The governors also help the pilot control the collective pitch on the helicopter's main rotors, to keep a stable, more accurate flight.
Cyclic/collective pitch mixing (CCPM) is a control concept employed in collective pitch radio-controlled helicopters. [1] CCPM reduces mechanical complexity and increases precision of control of the helicopter rotor's swashplate. Unlike conventional systems in which a single actuator is responsible for a single axis, CCPM mechanisms allow ...
1. Non-rotating outer ring (blue). 2. Turning inner ring (silver). 3. Ball joint. 4. Control (pitch) preventing turning of outer ring. 5. Control (roll). 6. Linkages (silver) to the rotor blade. In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades.
To pitch forward and accelerate, both rotors increase the pitch at the rear and reduce the pitch at the front (cyclic) keeping torque the same on both rotors, flying sideways is achieved by increasing the pitch on one side and reducing pitch on the other. Yaw control develops through opposing cyclic pitch in each rotor.
The pilot's primary control of the rate of descent is airspeed. Higher or lower airspeeds are obtained with the cyclic pitch control just as in normal flight. Rate of descent is high at zero airspeed and decreases to a minimum at approximately 50 to 90 knots, depending upon the particular helicopter and the factors previously mentioned.
A helicopter's main rotor hub. The vertical rods are at the end of the control chain that starts with the pilot controls. Helicopter flight controls are connected to the main and tail rotors, and include a cyclic stick, broadly to control forward-aft and left-right movements, a collective lever, broadly to control vertical movements, and anti-torque pedals, to control left and right yaw.
Blade pitch control is a feature of nearly all large modern horizontal-axis wind turbines.It is used to adjust the rotation speed and the generated power. While operating, a wind turbine's control system adjusts the blade pitch to keep the rotor speed within operating limits as the wind speed changes.
A controllable-pitch propeller is one where the pitch is controlled manually by the pilot. Alternatively, a constant-speed propeller is one where the pilot sets the desired engine speed ( RPM ), and the blade pitch is controlled automatically without the pilot's intervention so that the rotational speed remains constant.