Search results
Results from the WOW.Com Content Network
Oceanic eddies are also usually made of water masses that are different from those outside the eddy. That is, the water within an eddy usually has different temperature and salinity characteristics to the water outside the eddy. There is a direct link between the water mass properties of an eddy and its rotation.
Mode-water eddies have a complex density structure. Due to their shape, they cannot be distinguished from regular anticyclones in an eddy-centric (focused on the core of the eddy) analysis based on sea level height. Nonetheless, eddy pumping induced vertical motion in the euphotic zone of mode-water eddies is comparable to cyclones.
Water management authorities said they were still considering whether to open an emergency reservoir to protect Hungary's northwestern town of Mosonmagyarovar on the Austrian border, as the Leitha ...
Von Kármán swirling flow is a flow created by a uniformly rotating infinitely long plane disk, named after Theodore von Kármán who solved the problem in 1921. [1] The rotating disk acts as a fluid pump and is used as a model for centrifugal fans or compressors.
A whirlpool is a body of rotating water produced by opposing currents or a current running into an obstacle. [1] [clarification needed] Small whirlpools form when a bath or a sink is draining. More powerful ones formed in seas or oceans may be called maelstroms (/ ˈ m eɪ l s t r ɒ m,-r ə m / MAYL-strom, -strəm).
A flow straightener, sometimes called a honeycomb, is a device used to straighten the air flow in a wind tunnel. It is a passage of ducts, laid along the axis of main air stream to minimize the lateral velocity components caused by swirling motion in the air flow during entry.
The stirring makes the water spin in the cup, causing a centrifugal force outwards. Near the bottom however, the water is slowed by friction. Thus the centrifugal force is weaker near the bottom than higher up, leading to a secondary circular (helical) flow that goes outwards at the top, down along the outer edge, inwards along the bottom, bringing the leaves to the center, and then up again.
Some water wheels are fed by water from a mill pond, which is formed when a flowing stream is dammed. A channel for the water flowing to or from a water wheel is called a mill race. The race bringing water from the mill pond to the water wheel is a headrace; the one carrying water after it has left the wheel is commonly referred to as a ...