Search results
Results from the WOW.Com Content Network
Swingline is a division of ACCO Brands Corporation that specializes in manufacturing staplers and hole punches. From its foundation in 1925, the company was located in Long Island City, Queens , New York , United States , until the plant was moved to Nogales , Mexico, in 1999.
Book review index Media review digest From 1842 to 1899 each year includes "Punch's almanack." Beginning with 1900 the almanac is issued separately
An IBM 80-column punched card of the type most widely used in the 20th century IBM 1442 card reader/punch for 80 column cards. A computer punched card reader or just computer card reader is a computer input device used to read computer programs in either source or executable form and data from punched cards.
The IBM 056 verifier used most of the same mechanical and electrical components as the 024/026 keypunches with the exception of the punch unit and print head. The punch unit had sensing pins in place of the punches. The holes sensed or not sensed would trip a contact bail when the configuration was other than that entered by the verifier operator.
This machine would punch a received teleprinter signal into tape and print the message on it at the same time, using a printing mechanism similar to that of an ordinary page printer. The tape punch, rather than punching out the usual round holes, would instead punch little U-shaped cuts in the paper, so that no chad would be produced; the "hole ...
An exploded view of an automatic center punch. An automatic center punch is a hand tool used to produce a dimple in a workpiece (for example, a piece of metal). It performs the same function as an ordinary center punch but without the need for a hammer.
A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...
A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]