Search results
Results from the WOW.Com Content Network
A split nut is a nut that is split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew. [1] This allows the nut, when open, to move along the screw without the screw turning (or, vice versa, to allow the screw to pass through the nut without turning).
J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut: Collar nut Has a wide flange at one end that acts as an integrated washer HARDLOCK Nut [3] Eccentric Double Nut
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
Spherical washer nut and screw Part of a self-aligning nut; it is a washer with one radiused surface, which is designed to be used in conjunction with a mating nut in order to allow for up to several degrees of misalignment between parts. [4] Anchor plate or wall washer A large plate or washer connected to a tie rod or bolt.
A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.
A plate nut, also known as a nut plate, anchor nut or anchor plate, is a stamped sheet metal nut that is usually riveted to a workpiece. They have a long tube that is internally threaded and a plate with two clearance holes for rivets. The most popular versions have two lugs and they exist as fixed anchor nuts [1] and as floating anchor nuts. [2]
This is better than on Dana 60 “standard duty” where tube reinforcement extends diagonally to join with the cover flange. Some Dana 61s shared a common carrier with the Dana 60 part #706040x, [2] which means the gearsets (3.07-4.10) will interchange between the two.
A split nut can also be used to compensate for wear by compressing the parts of the nut. A hydrostatic leadscrew overcomes many of the disadvantages of a normal leadscrew, having high positional accuracy, very low friction, and very low wear, but requires continuous supply of high-pressure fluid and high-precision manufacture, leading to ...