Search results
Results from the WOW.Com Content Network
Slope may still be expressed when the horizontal run is not known: the rise can be divided by the hypotenuse (the slope length). This is not the usual way to specify slope; this nonstandard expression follows the sine function rather than the tangent function, so it calls a 45 degree slope a 71 percent grade instead of a 100 percent. But in ...
Slope illustrated for y = (3/2)x − 1.Click on to enlarge Slope of a line in coordinates system, from f(x) = −12x + 2 to f(x) = 12x + 2. The slope of a line in the plane containing the x and y axes is generally represented by the letter m, [5] and is defined as the change in the y coordinate divided by the corresponding change in the x coordinate, between two distinct points on the line.
Buffalo, New York and Montreal, Quebec, Canada, specify 6 in 12, a pitch of approximately 26.6 degrees. [3] A flat roof includes pitches as low as 1 ⁄ 2:12 to 2:12 (1 in 24 to 1 in 6), which are barely capable of properly shedding water. Such low-slope roofs (up to 4:12 (1 in 3)) require special materials and techniques to avoid leaks. [4]
The world average river reach slope is 2.6 m/km or 0.26%; [2] a slope smaller than 1% and greater than 4% is considered gentle and steep, respectively. [3] Stream gradient may change along the stream course. An average gradient can be defined, known as the relief ratio, which gives the average drop in elevation per unit length of river. [4]
Typically on straight road sections, the drainage gradient is at least 1–3% due to the normal cross slope of 1–3%. In curved sections the drainage gradient is higher, and may often reach 5–12% due to superelevated CS that may reach 5–8% in areas with icy roads and up to 12% in areas without icy roads.
Metros and pure commuter railways often also allow steeper gradients, over 4%, for the same reason. High-speed railways commonly allow 2.5% to 4% because the trains must be strong and have many wheels with power to reach very high speeds. For freight trains, gradients should be as gentle as possible, preferably below 1.5%.
A wide variety of river and stream channel types exist in limnology, the study of inland waters.All these can be divided into two groups by using the water-flow gradient as either low gradient channels for streams or rivers with less than two percent (2%) flow gradient, or high gradient channels for those with greater than a 2% gradient.
Some gradients use per mil (e.g ... permill 45 degrees is 1 in 1 or 1000 permill 30 degrees is 1 in 1.73205080756888 or 577.350269189626 permill 20 degrees is 1 in 2. ...