Search results
Results from the WOW.Com Content Network
Diode logic (or diode-resistor logic) constructs AND and OR logic gates with diodes and resistors. An active device ( vacuum tubes with control grids in early electronic computers , then transistors in diode–transistor logic ) is additionally required to provide logical inversion (NOT) for functional completeness and amplification for voltage ...
Diode–resistor logic constructs AND and OR logic gates. Functional completeness can be achieved by adding an active device to provide inversion (as done with diode–transistor logic ). Ionizing radiation detectors
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
A diode-OR circuit is used in electronics to isolate two or more voltage sources. There are two typical implementations: There are two typical implementations: When a DC supply voltage needs to be generated from one of a number of different sources, for example when terminating a parallel SCSI bus, a very simple circuit like this can be used:
Three-state logic: Consists of transistors to source and sink current in both logic states, as well as a control to turn off both transistors to isolate the output. This differs from open collector/drain output, which only use a single transistor that can only disconnect the output or connect it to ground.
Diode–transistor logic (DTL) was used in the IBM 608 which was the first all-transistorized computer. Early transistorized computers were implemented using discrete transistors, resistors, diodes and capacitors. The first diode–transistor logic family of integrated circuits was introduced by Signetics in 1962.
The base diode allows a Si diode clamp to be used with a Si transistor and keeps V CE around a diode drop and much greater than V CE(sat). Unfortunately, it turns off and creates a high-impedance return path when trying to turn the transistor off. Although the base charge has been minimized, it is now more difficult to draw charge out of the base.
See also: Diode logic § Active-high AND logic gate Open-collector buffers connected as wired AND.. The wired AND connection is a form of AND gate.When using open collector or similar outputs (which can be identified by the ⎐ symbol in schematics), wired AND only requires a pull up resistor on the shared output wire.