Ad
related to: standing water around well head pump installation diagram
Search results
Results from the WOW.Com Content Network
When the well has been drilled, it is completed to provide an interface with the reservoir rock and a tubular conduit for the well fluids. The surface pressure control is provided by a Christmas tree, which is installed on top of the wellhead, with isolation valves and choke equipment to control the flow of well fluids during production.
A diagram of a pumpjack. A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1] It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface. The arrangement is often used for onshore wells. Pumpjacks are common in oil-rich areas.
Water pumping stations are differentiated from wastewater pumping stations in that they do not have to be sized to account for high peak flow rates. They have five general categories: [3] Source (such as a well) pump discharging into an elevated tank; Raw water pumping from a river or lake; In-line booster pumping into an elevated tank
In a completed well, there may be many annuli. The 'A' annulus is the void between the production tubing and the smallest casing string. The 'A' annulus can serve a number of crucial tasks, including gas lift and well kills. A normal well will also have a 'B' and frequently a 'C' annulus, between the different casing strings.
On Earth, additional height of fresh water adds a static pressure of about 9.8 kPa per meter (0.098 bar/m) or 0.433 psi per foot of water column height. The static head of a pump is the maximum height (pressure) it can deliver. The capability of the pump at a certain RPM can be read from its Q-H curve (flow vs. height).
In subsurface hydrogeology, drawdown is the reduction in hydraulic head observed at a well in an aquifer, typically due to pumping a well as part of an aquifer test or well test. In surface water hydrology and civil engineering, drawdown refers to the lowering of the surface elevation of a body of water, the water table, the piezometric surface ...
The three water injection pumps each had a capacity of 221 m 3 /hr with a differential head of 2068.5 metres (209 bar). The pumps discharged to the 3,000 psi manifold and wellheads. The single water injection booster pump (221 m 3 /hr, 1,379 m (139 bar) differential head) took its suction from the discharge of the water injection pumps and ...
The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower and a need for pumping water to a destination ...
Ad
related to: standing water around well head pump installation diagram