Search results
Results from the WOW.Com Content Network
In most communication systems, the transmitting point applies source coding, [2] followed by channel coding, and lastly, line coding. This produces the baseband signal. The presence of filters may perform pulse shaping. Some systems then use modulation to multiplex many baseband signals into a broadband signal. The receiver un-does these ...
In data communications, flow control is the process of managing the rate of data transmission between two nodes to prevent a fast sender from overwhelming a slow receiver. Flow control should be distinguished from congestion control , which is used for controlling the flow of data when congestion has actually occurred. [ 1 ]
In asynchronous serial communication, a signal at the end of a character that prepares the receiving device for the reception of a subsequent character. A stop signal is usually limited to one signal element having any duration equal to or greater than a specified minimum value. A signal to a receiving mechanism to wait for the next signal.
Stop (logic high (1)): the next one or two bits are always in the mark (logic high, i.e., 1) condition and called the stop bit(s). They signal to the receiver that the character is complete. Since the start bit is logic low (0) and the stop bit is logic high (1) there are always at least two guaranteed signal changes between characters.
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
The time-stretched and slowed down signal segments are then converted into digital samples by slow electronic ADCs. Finally, these samples are collected by a digital signal processor (DSP) and rearranged in a manner such that output data is the digital representation of the original analog signal.
In signal processing, a filter is a device or process that removes some unwanted components or features from a signal.Filtering is a class of signal processing, the defining feature of filters being the complete or partial suppression of some aspect of the signal.
The term is only relevant in the case of signaling systems that use discrete signals (e.g. a combination of tones to denote one digit), as opposed to signaling systems which are message-oriented (such as SS7 and ISDN Q.931) where each message is able to convey multiple items of formation (e.g. multiple digits of the called telephone number).