Search results
Results from the WOW.Com Content Network
In this variation the pivot is located in the front of the binding. [15] ISO 9523:2015, for boots in which the pivot is formed at the boot / binding interface. [16] The two setups are typically incompatible in that the principle by which they affix the boot to the ski is different.
Above the top buckle on the leg is the "power strap", which acts as a fifth buckle. The rivets forming the pivot points that allow the upper and lower portions of the boot to move independently are seen in silver. Modern alpine ski boots have rigid soles and attach to the ski at both toe and heel using a spring-loaded binding.
Help; Learn to edit; Community portal; Recent changes; Upload file; Special pages
The pivot turn or pivot is a technique of turning in place in skiing. The two types are the tail pivot and tip pivot. In the tail pivot, e.g., to the left, little turning steps are done to the left while keeping the tails of the skis together in place. Repeat the following two steps until the required amount of turn is reached: step the front ...
Various models of the Pivot were Look's primary offering into the 1990s. When Look was purchased in 1994 by Rossignol, they re-branded the Pivot under their own name. Look-branded versions re-appeared in 2009. [5] Throughout its long history, Look's only other major binding design was the Look Integral, which was aimed at ski rental shops.
This led to further design improvements, and eventually to a 1969 production run of 1000 pairs of bindings from the newly formed Spademan Release Systems, Inc. [2] Continual improvements followed to allow the binding to hold more strongly, and by the winter of 1974/75 the binding was a must-have on the pro freestyle skiing circuit.
In the case of a binding release, the cable prevented the ski from running away down the hill, a task normally accomplished at that time with a separate strap tied around the skier's leg, and today with a ski brake. The spring would then automatically pull the ski back to the user and, if properly aligned, reconnect it. [2] [3] [5]
A cable binding with boot, typical of the gear used by the US 10th Mountain Division in World War II and most alpine skiers, including racers, beginning around 1932. Cable bindings , also known as Kandahar bindings or bear-trap bindings , are a type of ski bindings widely used through the middle of the 20th century.