Search results
Results from the WOW.Com Content Network
An Ethernet extender (also network extender or LAN extender) is any device used to extend an Ethernet or network segment beyond its inherent distance limitation which is approximately 100 metres (330 ft) for most common forms of twisted pair Ethernet. These devices employ a variety of transmission technologies and physical media (wireless ...
By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables.
Fast Ethernet is an extension of the 10-megabit Ethernet standard. It runs on twisted pair or optical fiber cable in a star wired bus topology, similar to the IEEE standard 802.3i called 10BASE-T, itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a). Fast Ethernet devices are generally backward compatible with existing 10BASE-T systems ...
For many years during the mid to late 1980, this was the dominant Ethernet standard. Also called Thin Ethernet, Thinnet or Cheapernet. 10 Mbit/s over RG-58 coaxial cabling, bus topology with collision detection. Deprecated 2011. 10BROAD36: 802.3b-1985 (11) F: 1800 m @VF0.87 [10] 75 Ω coaxial An early standard supporting Ethernet over longer ...
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
The maximum practical number of nodes that can be connected to a 10BASE2 segment is limited to 30 [4] with a minimum distance of 0.5 metres (20 in) between devices. [5] In a 10BASE2 network, each stretch of cable is connected to the transceiver (which is usually built into the network adaptor) using a BNC T-connector , [ a ] with one stretch ...
A converged network adapter (CNA), also called a converged network interface controller (C-NIC), is a computer input/output device that combines the functionality of a host bus adapter (HBA) with a network interface controller (NIC).
Autonegotiation can be used by devices that are capable of more than one transmission rate, different duplex modes (half duplex and full duplex), and different transmission standards at the same speed (though in practice only one standard at each speed is widely supported).