Search results
Results from the WOW.Com Content Network
The cruciform tail is an aircraft empennage configuration which, when viewed from the aircraft's front or rear, looks much like a cross. The usual arrangement is to have the horizontal stabilizer intersect the vertical tail somewhere near the middle, and above the top of the fuselage .
Pages in category "Cruciform tail aircraft" The following 114 pages are in this category, out of 114 total. This list may not reflect recent changes. ...
Faulty repair after same plane suffered a tailstrike: the rear bulkhead failed which caused the tail fin to fall off and rupture all four hydraulic systems. The crash remains the deadliest single-aircraft accident in aviation history. 1987-11-28 South African Airways Flight 295: Indian Ocean, 134 nautical miles (248 km) north-east of Mauritius,
The empennage of an Atlas Air Boeing 747-200. The empennage (/ ˌ ɑː m p ɪ ˈ n ɑː ʒ / or / ˈ ɛ m p ɪ n ɪ dʒ /), also known as the tail or tail assembly, is a structure at the rear of an aircraft that provides stability during flight, in a way similar to the feathers on an arrow.
The Goodyear Aircraft Corporation began to design a small light amphibian before the end of the Second World War. The prototype designated GA-1 first flew in September 1944. It was a cantilever high-wing monoplane with underwing stabilizing floats. The GA-1 had an all-metal fabric-covered wing, an all-metal single-step hull, and a cruciform ...
The Teal was based on the two- or three-seat AMF Maranda, and was built mostly of wood.It featured strut-braced high wing, with "W" configuration struts running from the wing roots, down to stabilizing floats (which also contained the main wheels), then back up the wings near 70% span; cruciform tail; two pilots seated side by side under the wing; access to the cockpit by side doors; tricycle ...
The Aerodrome had a primitive control system that included a cruciform tail and a centrally-mounted rudder. [3] Langley again used a houseboat catapult for launch. He chose his chief engineer, Charles M. Manly, to ride the aircraft and operate the controls as best he might. On the first flight attempt, October 7, 1903, the craft failed to fly ...
The de Havilland Canada DHC-3 Otter is a single-engined, high-wing, propeller-driven, short take-off and landing aircraft developed by de Havilland Canada.It was conceived to be capable of performing the same roles as the earlier and highly successful Beaver, including as a bush plane, but is overall a larger aircraft.