Search results
Results from the WOW.Com Content Network
Connectors are identical for USB 2.0 and USB 1.x. SuperSpeed (SS) rate of 5.0 Gbit/s. The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5]
This is a USB 3.0 Y-cable. Traditional USB Y-cables exist to enable one USB peripheral device to receive power from two USB host sockets at once, while only transceiving data with one of those sockets. As long as the host has two available USB sockets, this enables a peripheral that requires more power than one USB port can supply (but not more ...
Some ExpressCard-to-USB 3.0 adapters may connect by a cable to an additional USB 2.0 port on the computer, which supplies additional power. The ExpressCard may have a socket for an external power supply. If the external device has an appropriate connector, it can be powered by an external power supply.
The throughput of each USB port is determined by the slower speed of either the USB port or the USB device connected to the port. High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port.
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.
The USB 3.0 Micro-B plug effectively consists of a standard USB 2.0 Micro-B cable plug, with an additional 5 pins plug "stacked" to the side of it. In this way, cables with smaller 5 pin USB 2.0 Micro-B plugs can be plugged into devices with 10 contact USB 3.0 Micro-B receptacles and achieve backward compatibility.
For example, if a USB 1.1 device is connected to a port on a USB 2.0 hub, then the TT would automatically recognize and translate the USB 1.1 signals to USB 2.0 on the uplink. However, the default design is that all lower-standard devices share the same transaction translator and thus create a bottleneck, a configuration known as the single ...
Formally, a cable type and properties are defined by a distinct specification version, which was used during the development/design of said cable model, so each cable would be a valid and possibly certified cable according to a specific set of USB specification versions, like "Type-C 2.3, USB 3.2, USB4 Version 2.0".