Search results
Results from the WOW.Com Content Network
The block has cast iron main caps and a cast iron crankshaft. The engine's cylinder head is cast iron for lower cost, structural integrity and longer camshaft bearing life. The valvetrain features a direct-acting single overhead camshaft design. [1] The engine block and cylinder heads were cast at Massena Castings Plant in Massena, New York.
The 267 was introduced in 1979 for the GM F-body (Camaro), G-body (Chevrolet Monte Carlo, El Camino), A-body (Malibu Classic, 1979–1981) and also used on GM B-body cars (Impala and Caprice models). The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88 ...
The 318-cubic-inch (5.2 L) 318 was released in 1950, replacing the 308. It shared the same 4 + 1 ⁄ 2 inches (110 mm) stroke as its predecessors but with a slightly larger 3 + 7 ⁄ 8 inches (98 mm) bore. It produced a maximum 136 hp @ 3400 rpm and 245 lb•ft @ 1400 rpm. [2] The 308 was discontinued in 1954 and replaced by the 324 cubic inch ...
The Mercury Y-Block was 256 cu in (4,194 cc) and produced 161 bhp (120 kW), [3] again a similar displacement to the 255 cu in (4.2 L) Mercury Flathead V8 it replaced, but with 29% more power than the older engine's 125 bhp (93 kW). [4] The original Lincoln V8 was also known as a Y-Block. Lincoln introduced their engine in 1952, but it was a ...
The first version of this engine family was a normally aspirated 2.2 L (134 cu in) unit. Developed under the leadership of Chief Engineer – Engine Design and Development Willem Weertman and head of performance tuning Charles "Pete" Hagenbuch, who had worked on most of Chrysler's V-8 engines and the Chrysler Slant-6 engine, [1] it was introduced in the 1981 Dodge Aries, Dodge Omni, Plymouth ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Z28 models included a stripe package that was not deletable and featured the LM1 a 350 cu in (5.7 L) V8 with a four-barrel Quadrajet carburetor that produced 185 hp (138 kW; 188 PS) and 280 lb⋅ft (380 N⋅m) of torque, coupled to either a 4-speed manual or a TH-350 3-speed automatic. A non-functioning hood scoop was outlined with a decal ...
The engine has a displacement of 2.0 L; 121.9 cu in (1,998 cc) with a bore and a stroke of 3.38 in × 3.38 in (86 mm × 86 mm). [2] The compression ratio of the engine is 10.5:1. [2] The 2.0 L engine was offered by Dodge in the Dodge Caliber. Outside North America, the 2.0 was the base engine for the 2007 Chrysler Sebring and 2008 Dodge Avenger.