enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. OBD-II PIDs - Wikipedia

   en.wikipedia.org/wiki/OBD-II_PIDs

   OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .

3. On-board diagnostics - Wikipedia

   en.wikipedia.org/wiki/On-board_diagnostics

   A range of rugged hand-held scan tools is available. Simple fault code readers/reset tools are mostly aimed at the consumer level. Professional hand-held scan tools may possess more advanced functions Access more advanced diagnostics; Set manufacturer- or vehicle-specific ECU parameters; Access and control other control units, such as air bag ...

4. Scan tool - Wikipedia

   en.wikipedia.org/wiki/Scan_tool

   OBD 1 vs OBD 2 the vehicle will also dictate what the scan tool is able to display. If the vehicle is equipped with OBD 1 it will have significantly less available data when compared to a vehicle equipped with OBD 2. [2] When a vehicle detects a problem, it generates a DTC code which is a unique code that corresponds to the specific problem ...

5. ELM327 - Wikipedia

   en.wikipedia.org/wiki/ELM327

   The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.

6. CAN bus - Wikipedia

   en.wikipedia.org/wiki/CAN_bus

   A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.

7. Data link connector - Wikipedia

   en.wikipedia.org/wiki/Data_link_connector

   The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...

8. SAE J1939 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1939

   SAE J1939 defines five layers in the seven-layer OSI network model, and this includes the Controller Area Network (CAN) ISO 11898 specification (using only the 29-bit/"extended" identifier) for the physical and data-link layers. Under J1939/11 and J1939/15, the data rate is specified as 250 kbit/s, with J1939/14 specifying 500 kbit/s.

9. VCDS (software) - Wikipedia

   en.wikipedia.org/wiki/VCDS_(software)

   Unlike generic on-board diagnostics (OBD-II or EOBD), VCDS uses the more in-depth Volkswagen Group-specific manufacturer protocol commands, [4] which allows the user to access all diagnostic capable vehicle systems — even in vehicles which are not covered by generic OBD-II/EOBD (e.g. pre-1996).