Search results
Results from the WOW.Com Content Network
This prevents the non-test ear from detecting the test signal presented to the test ear. The threshold of the test ear is measured at the same time as presenting the masking noise to the non-test ear. Thus, thresholds obtained when masking has been applied, provide an accurate representation of the true hearing threshold level of the test ear. [13]
Lindos Electronics expanded the concept, retaining the FSK concept, and inventing segmented sequence testing, which separated each test into a 'segment' starting with an identifying character transmitted as 110-baud FSK so that these could be regarded as 'building blocks' for a complete test suited to a particular situation. Regardless of the ...
A major use of noise weighting is in the measurement of residual noise in audio equipment, usually present as hiss or hum in quiet moments of programme material. The purpose of weighting here is to emphasise the parts of the audible spectrum that ears perceive most readily, and attenuate the parts that contribute less to perception of loudness, in order to get a measured figure that correlates ...
Weber test; Bing test; Rinne test; Schwabach test, a variant of the Rinne test; Pure tone audiometry is a standardized hearing test in which air conduction hearing thresholds in decibels (db) for a set of fixed frequencies between 250 Hz and 8,000 Hz are plotted on an audiogram for each ear independently. A separate set of measurements is made ...
Audiogram. An audiogram is a graph that shows the audible threshold for standardized frequencies as measured by an audiometer.The Y axis represents intensity measured in decibels (dB) and the X axis represents frequency measured in hertz (Hz). [1]
A variety of terms such as 'line-up level' and 'operating level' exist, and their meaning may vary from place to place. In an attempt bring clarity to level definitions in the context of programme transmission from one country to another, where different technical practices may apply, ITU-R Rec. BS.645 defined three reference levels: Measurement Level (ML), Alignment Level (AL) and Permitted ...
The first research on the topic of how the ear hears different frequencies at different levels was conducted by Fletcher and Munson in 1933. Until recently, it was common to see the term Fletcher–Munson used to refer to equal-loudness contours generally, even though a re-determination was carried out by Robinson and Dadson in 1956, which became the basis for an ISO 226 standard.
The nominal level and the reference voltage against which it is expressed depend on the line level being used. While the nominal levels themselves vary, only two reference voltages are common: decibel volts (dBV) for consumer applications, and decibels unloaded (dBu) for professional applications. The decibel volt reference voltage is 1 V RMS ...