Search results
Results from the WOW.Com Content Network
In computing, route is a command used to view and manipulate the IP routing table in Unix-like and Microsoft Windows [1] operating systems and also in IBM OS/2 and ReactOS. [2] Manual manipulation of the routing table is characteristic of static routing .
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
Static routes, connected routes, and routes from dynamic configuration protocols can be redistributed by dynamic routing protocols. For instance a router may have a static or connected route for a local network segment, which is then redistributed over dynamic routing protocols to enable connectivity to that network. [4] By using the metric to ...
default or static routes that are manually configured, [3] [4] on-demand routing, [5] dynamic routing protocols, [6] or; Policy-based routing. [7] In a small network such as a home or home office, a default route is often used to send all traffic to the user's Internet service provider.
The letter "S" indicates that the route is a static route that has, for all intents and purposes, been added manually to the router process by the administrator and installed into the routing table. Router#enable Router#configure terminal Router(config)#ip route 1.1.1.0 255.255.255.0 fastEthernet 0/0 Router(config)#do show ip route
An ephemeral port is a communications endpoint of a transport layer protocol of the Internet protocol suite that is used for only a short period of time for the duration of a communication session. Such short-lived ports are allocated automatically within a predefined range of port numbers by the IP stack software of a computer operating system.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
eth0 is the interface name of the network interface card representing an Ethernet port. ppp0 is a PPPoE interface, which is configured as the default route in this example. A default route is recognized by the destination 0.0.0.0 and the flag G. A network router is identified by the network mask 255.255.255.255 and the flag H.