Ads
related to: relay optocoupler circuit
Search results
Results from the WOW.Com Content Network
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
High voltage interface relays, a.k.a., interface relays: [1] [2] or coupling relays or insulating interfaces [3] [4] is a special class of electrical relays designed to provide informational and electrical compatibility between functional components isolated from each other and not allowing for a direct connection due to a high difference of potentials.
Opto-isolator VTL2C1 with LED input and photoresistor output. Resistive opto-isolator (RO), also called photoresistive opto-isolator, vactrol (after a genericized trademark introduced by Vactec, Inc. in the 1960s), analog opto-isolator [notes 1] or lamp-coupled photocell, [1] is an optoelectronic device consisting of a source and detector of light, which are optically coupled and electrically ...
An opto-isolator is a very popular method of isolation in digital circuits. Cross-section of dual in-line package opto-isolators. Relative sizes of LED (red) and sensor (green) are exaggerated. Everlight EL817 phototransistor opto-isolator in DIP-4 package Halo TG110-S050N2RL 10/100BASE-TX Ethernet pulse transformer in SO-16 package.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Basic fixed-threshold comparator and its derivatives - simple time delay relay and cascaded window monitor. To ensure fast turn-off transients, load resistor RL should provide on-state current of at least 5 mA [39] The simplest TL431-based comparator circuit requires a single external resistor to limit I CA at around 5 mA. [39]
The open collector transistor can be rated to withstand a higher voltage than the chip supply voltage. This technique is commonly used by logic circuits operating at 5 V or lower to drive higher voltage devices such as electric motors, LEDs in series, [8] 12 V relays, 50 V vacuum fluorescent displays, or Nixie tubes requiring more than 100 V.
A relay allows circuits to be switched by electrical equipment: for example, a timer circuit with a relay could switch power at a preset time. For many years relays were the standard method of controlling industrial electronic systems. A number of relays could be used together to carry out complex functions (relay logic). The principle of relay ...
Ads
related to: relay optocoupler circuit