Ad
related to: jeep gladiator transfer case fluidebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The Dana 300 part-time gear-driven transfer case. [2] That uses a round bolt pattern and has a nearly flat oil pan. It is a heavy-duty, gear-driven transfer case with a 23-spline input shaft. The case is cast iron but the tail housing is aluminum. The ID number C300-15 is stamped on the case.
The transfer case has no center differential, so power can only be supplied to the front axle when the rear wheels begin to slip. In this way, the transfer case works almost identically to the NV247 transfer case used in the Quadra-Trac II system in 1999 to 2004 WJ Jeep Grand Cherokees.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
It also gets a locking rear differential and Jeep's Command-Trac 4x4 part-time, two-speed transfer case with a 2.72:1 low-range gear ratio is also standard fare. The Willys Edition has a hood decal, retro-looking 4WD tailgate decal, 17-inch black aluminum wheels with gray pad print, and a gloss black grille.
The 1 + 1 ⁄ 4-ton, 4×4, Kaiser Jeep M715, sometimes called the "Five quarter (ton)", for its 1 + 1 ⁄ 4 (or 5 ⁄ 4) ton payload rating, is an American light military truck, based on the civilian Jeep Gladiator (SJ). Design and development for the M715 began in 1965, intended to replace the Dodge M37.
The Jeep Truck was available with only one transmission, the Borg-Warner T-90 three-speed manual, with synchromeshed second and third gears. A Spicer/Dana 18 transfer case was used on four-wheel drive models. The heavy duty Timken 51540 was used in the early years of production, later being replaced by the Dana 53.
The Syracuse New Process Gear plant produced transfer cases for all of the "Big Three"—Ford, Chrysler, and General Motors. The NV247 all-wheel drive transfer case, sold by Chrysler's Jeep division as the "Quadra-Trac II," the manual transaxle for the Dodge Neon and PT Cruiser (T-350), and manual transaxles for European-export Chrysler ...
The Jeep Gladiator, Jeep Pickup or J-series is a series of full-size pickup trucks based on the large Jeep SJ platform, which was built and sold under numerous marques from 1962 until 1988. The Jeep Gladiator/Pickup design is noteworthy for remaining in production for more than 26 years on a single automobile platform generation.
Ad
related to: jeep gladiator transfer case fluidebay.com has been visited by 1M+ users in the past month