Search results
Results from the WOW.Com Content Network
With the stratified-charge application, the 3.0L V-6 will continue to employ direct fuel injection, but the injectors have been redesigned to spray under higher pressure later in the intake stroke, just before compression, and the fuel is shaped to arrive in certain areas within the cylinder to optimize combustion.
Gasoline direct injection (GDI), also known as petrol direct injection (PDI), [1] is a mixture formation system for internal combustion engines that run on gasoline (petrol), where fuel is injected into the combustion chamber. This is distinct from manifold injection systems, which inject fuel into the intake manifold (inlet manifold).
common rail (CR) direct diesel injection: electric low-pressure fuel lift pump, one timing belt-driven 1,600 bar (23,210 psi) injection pump, two common rail fuel rails (one per cylinder bank), piezo-electric operated fuel injectors with eight-hole nozzles for homogenous fuel delivery, single and double pilot injection, up to four main ...
The Ramjet is a continuous-flow port-injection system. Unlike later fuel injection systems that used electronics, this one is based on purely mechanical principles. The two main sub-assemblies of the system are the air meter and the fuel meter. The air meter measures airflow into the engine and manages thermostatic warmup enrichment, fuel ...
In a continuous injection system, fuel flows at all times from the fuel injectors, but at a variable flow rate. The most common automotive continuous injection system is the Bosch K-Jetronic system, introduced in 1974 and used until the mid-1990s by various car manufacturers.
Common rail fuel system on a Volvo truck engine. In 1916 Vickers pioneered the use of mechanical common rail systems in G-class submarine engines. For every 90° of rotation, four plunger pumps allowed a constant injection pressure of 3,000 pounds per square inch (210 bar; 21 MPa), with fuel delivery to individual cylinders being shut off by valves in the injector lines. [1]
In most contexts a mention of rate of fluid flow is likely to refer to the volumetric rate. In hydrometry, the volumetric flow rate is known as discharge. Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1.
[4] [5] [6] A generalized model of the flow distribution in channel networks of planar fuel cells. [6] Similar to Ohm's law, the pressure drop is assumed to be proportional to the flow rates. The relationship of pressure drop, flow rate and flow resistance is described as Q 2 = ∆P/R. f = 64/Re for laminar flow where Re is the Reynolds number.