Search results
Results from the WOW.Com Content Network
A second function of the PCV valve is to act as a flame arrester and to prevent positive pressure from the intake system from entering the crankcase. This can happen on turbocharged engines or when a backfire takes place, and the positive pressure could damage the crankcase seals and gaskets, or even cause a crankcase explosion.
The functional objective for the crankshaft position sensor is to determine the position and/or rotational speed of the crank.Engine Control Units use the information transmitted by the sensor to control parameters such as ignition timing and fuel injection timing.
A crankcase heater is an electrical component in a compressor in an air-conditioning system, heat pump system, or chiller system. The crankcase heater is normally on all the time, even when the unit is not running, though temperature sensors and set points may turn it off when not needed.
Partial stroke testing (or PST) is a technique used in a control system to allow the user to test a percentage of the possible failure modes of a shut down valve without the need to physically close the valve. PST is used to assist in determining that the safety function will operate on demand.
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
An engine test stand is a facility used to develop, characterize and test engines. The facility, often offered as a product to automotive OEMs , allows engine operation in different operating regimes and offers measurement of several physical variables associated with the engine operation.
These types of valves are also known as automatic control valves. The hydraulic actuators respond to changes of pressure or flow and will open/close the valve. Automatic control valves do not require an external power source, meaning that the fluid pressure is enough to open and close them.
A relief valve DN25 on cooling water pipe from heat exchanger Schematic diagram of a conventional spring-loaded pressure relief valve. A relief valve or pressure relief valve (PRV) is a type of safety valve used to control or limit the pressure in a system; excessive pressure might otherwise build up and create a process upset, instrument or equipment failure, explosion, or fire.