enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Punchcutting - Wikipedia

   en.wikipedia.org/wiki/Punchcutting

   Punchcutting is a craft used in traditional typography to cut letter punches in steel as the first stage of making metal type. [1] Steel punches in the shape of the letter would be used to stamp matrices into copper, which were locked into a mould shape to cast type. Cutting punches and casting type was the first step of traditional typesetting ...

3. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   One or more sheets of paper are inserted between the head and the die, with the flat face of the head parallel to the surface of the sheets. Moving the handle pushes the head straight through the sheets of paper. The hard edge of the punch vs the die cuts a hole in the paper, pushing the cut piece out the bottom of the die.

4. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.

5. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   This allows for complex shapes to be formed in sheet metal up to 6 mm (0.25 in) thick using simple tools. [4] that is essentially a small punch and die that reciprocates quickly; around 300–900 times per minute. Punches are available in various shape and sizes; oblong and rectangular punches are common because they minimize waste and allow ...

6. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]

7. Turret punch - Wikipedia

   en.wikipedia.org/wiki/Turret_punch

   The tooling of a turret punch uses a large number of standard punch tools: holes of varying sizes, straight edges, commonly-used notches or mounting holes. By using a large number of strokes, with several different tools in turn, a turret press may make a wide variety of parts without having to first make a specialised press tool for that task.