enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.

3. Cabinetry - Wikipedia

   en.wikipedia.org/wiki/Cabinetry

   A cabinet is a case or cupboard with shelves or drawers for storing or displaying items. Some cabinets are stand alone while others are built in to a wall or are attached to it like a medicine cabinet. Cabinets are typically made of wood (solid or with veneers or artificial surfaces), coated steel (common for medicine cabinets), or synthetic ...

4. Glossary of woodworking - Wikipedia

   en.wikipedia.org/wiki/Glossary_of_woodworking

   1. A deep channel cut in wood. 2. The cannel of a gouge. foxing A yellow-brown discoloration of wood caused by fungal infection. frame and panel. Also called rail and stile. frame saw. Also called a sash saw. French cleat A molding used to hang cabinets. fretsaw A type of saw with a very fine-toothed blade used for delicate cuts in thin ...

5. The Best Kitchen Cabinet Brands, According to Home ... - AOL

   www.aol.com/best-kitchen-cabinet-brands...

   The good news is that kitchen cabinet manufacturers carry a diverse array of product lines to serve a wide range of kitchen remodel budgets, from $10K or less for a cost-conscious cosmetic ...

6. Countertop - Wikipedia

   en.wikipedia.org/wiki/Countertop

   They are mounted in templated holes cut in the countertop (or substrate material) using a jigsaw or other cutter appropriate to the material at hand and are suspended by their rim. The rim forms a close fit, reinforced with a sealant, on the top surface of the countertop, especially when the sink is clamped into the hole from below.

7. Dado (joinery) - Wikipedia

   en.wikipedia.org/wiki/Dado_(joinery)

   A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...