Ads
related to: aux cable with volume controlebay.com has been visited by 1M+ users in the past month
discoverpanel.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The routing configuration and usage of an aux-send will vary depending on the application. Two types of aux-sends commonly exist: pre-fader and post-fader. Pre-fader sends are not affected by the main fader for the channel, while post-fader sends are affected by the position of the main fader slider control for the channel.
Virtual Audio Cable is a software product based on WDM multimedia driver that allows a user to transfer audio streams from one application to another. Any application is able to send an audio stream to the input side of a "virtual cable" while a corresponding application can receive this stream from the output side.
Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers to a type of analog video information that is transmitted or stored as three separate signals. Either RGB interfaces or YPbPr: 3 RCA jacks: Composite, S-Video, and Component: VIVO = Mini-DIN 9-pin with breakout cable.
For similar reasons, "wye"-cables (or "Y-splitters") should not be used to combine two line out signals into a single line in. Each line output would be driving the other line output as well as the intended input, again resulting in a much heavier load than designed for. This will result in signal loss and possibly even damage.
They often appeared next to a 3.5 mm microphone jack for a remote control on-off switch on early portable tape recorders; the microphone provided with such machines had the on-off switch and used a two-pronged connector with both the 3.5 and 2.5 mm plugs. They were also used for low-voltage DC power input from wall adapters.
The master control section is used to adjust the levels of the overall output of the mixer. The master control section on a large live venue or sound recording mixer typically has sub-group faders, master faders, master auxiliary mixing bus level controls and auxiliary return level controls. On most mixers, the master control is a fader.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A diagram showing the wiring of a Gibson Les Paul electric guitar. Shown are the humbucker pickups with individual tone and volume controls (T and V, respectively), 3-way pickup selector switch, tone capacitors that form a passive low-pass filter, the output jack and connections between those components.
Ads
related to: aux cable with volume controlebay.com has been visited by 1M+ users in the past month
discoverpanel.com has been visited by 10K+ users in the past month