Search results
Results from the WOW.Com Content Network
The system consists of a master antenna and a matching transformer to match the balanced antenna with unbalanced cable and amplifiers. [5] Most antennas have an impedance of around 300 Ω. To convert it to 75 Ω, a matching transformer (or balun) is used. For trunk line isolation, a resistive inductive device known as a splitter is used.
A short antenna pole next to a house Multiple Yagi TV aerials. Antennas are commonly placed on rooftops and sometimes in attics. Placing an antenna indoors significantly attenuates the level of the available signal. [19] [20] Directional antennas must be pointed at the transmitter they are receiving; in most cases great accuracy is not needed ...
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
Channel Master's original product was a prefabricated television aerial with hinged elements which would unfold and snap into place; this patented design greatly reduced installation time as existing antenna designs at the time had to be bolted together from multiple pieces by rooftop installers. [17]
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
An antenna array (or array antenna) is a set of multiple connected antennas which work together as a single antenna, to transmit or receive radio waves. [ 1 ] : p.149 [ 2 ] The individual antennas (called elements ) are usually connected to a single receiver or transmitter by feedlines that feed the power to the elements in a specific phase ...
An indoor antenna is a type of radio or TV antenna placed indoors, as opposed to being mounted on the roof. They are usually considered a simple and cheap solution to receive transmissions. An indoor antenna is prone to picking up electrical noise, but digital broadcasts are resistant to this noise.