Search results
Results from the WOW.Com Content Network
The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...
A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.
The Pitch Circle Diameter (PCD) is the diameter of that circle that passes through the center of all the bolt holes or wheel bolts or wheel rim holes or studs. The best example is Flanges, there are multiple holes in the Flanges, the circle through the center of these holes is known as the pitch circle, and the diameter of this circle is known ...
The thicker nut applies more force to the joint, first relieving the force on the threads of the thinner nut and then applying a force in the opposite direction. In this way the thicker nut presses tightly on the side of the threads away from the joint, while the thinner nut presses on the side of the threads nearest the joint, tightly locking ...
Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for fastening thicker materials. J bolt - Bolt shaped like the letter J, used for tie downs. Only the straight section is threaded for a nut.
A split beam nut, also known as a split hex nut [1] or slotted beam nut, [2] is a locknut with slots cut in the top that separate the outside end into two [3] or more sections that are bent slightly inward, making the thread diameter undersized in the slotted portion.
They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...
Some nuts do not attach to the workpiece. These are usually shaped as either a rectangle, a flange nut, or a hex nut; the rectangular speed nut is also known as a flat-style speed nut. Speed nuts that attach to the workpiece usually are some form of a J-nut or U-nut. [2] [3]