Search results
Results from the WOW.Com Content Network
Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system. EIFS has been in use since the 1960s in North America and was first used on masonry buildings.
A rainscreen is an exterior wall detail where the siding (wall cladding) stands off from the moisture-resistant surface of an air/water barrier applied to the sheathing to create a capillary break and to allow drainage and evaporation. The rainscreen is the cladding or siding itself [1] but the term rainscreen implies a system of building ...
It is also used in other construction applications such as fascias, soffit, shaft-liner and area separation, wall sheathing, and as tile backing (backer board) or as substrates for coatings and insulated systems such as finish systems, exterior insulation finishing systems, and some types of stucco.
Low cost and minimal upkeep make vinyl siding second only to stucco as the most popular exterior siding material for new construction. Vinyl siding, made from PVC resin, was first mass produced in ...
Types of External cromatic wall insulation systems (EWI Systems pictured above) An external wall insulation system (or EWIS) is a thermally insulated, protective, and decorative exterior cladding procedure involving the use of expanded polystyrene, mineral wool, polyurethane foam or phenolic foam, topped off with a reinforced cement based, mineral or synthetic finish and plaster.
Housewrap is installed between the sheathing and the exterior siding, and is used behind vinyl, wood clapboards, shingles or shakes, brick, and other building materials. In all cases, the housewrap helps prevent water intrusion when moisture in any form gets past the siding and its trim and caulking.
Exterior wall studs are the vertical members to which the wall sheathing and cladding are attached. [14] They are supported on a bottom plate or foundation sill and in turn support the top plate. Studs usually consist of 1 + 1 ⁄ 2 -by- 3 + 1 ⁄ 2 -inch (38 mm × 89 mm) or 1 + 1 ⁄ 2 -by- 5 + 1 ⁄ 2 -inch (38 mm × 140 mm) lumber and are ...
SIP systems were used by Woods Constructors of Santa Paula, California, in their homes and apartments from 1965 until 1984. This work was the basis for John Thomas Woods, Paul Flather Woods, John David Woods, and Frederick Thomas Woods when they used a similar concept to patent the Footing Form for Modular homes (US Patent No. 4817353) issued ...