Search results
Results from the WOW.Com Content Network
A block, a contiguous number of bytes, is the minimum unit of storage that is read from and written to a disk by a disk driver.The earliest disk drives had fixed block sizes (e.g. the IBM 350 disk storage unit (of the late 1950s) block size was 100 six-bit characters) but starting with the 1301 [8] IBM marketed subsystems that featured variable block sizes: a particular track could have blocks ...
Forensic disk controllers intercept write commands from the host operating system, preventing them from reaching the drive. Whenever the host bus architecture supports it the controller reports that the drive is read-only. The disk controller can either deny all writes to the disk and report them as failures, or use on-board memory to cache the ...
CHKDSK requires exclusive write access to the volume to perform repairs. [14] [15] Due to the requirement of the monopolized access to the drive, the CHKDSK cannot check the system disk in the normal system mode. Instead, the system sets a dirty bit to the disk volume and then reboots the computer.
Metadata (up to v2.50) and file data is addressed more or less directly. In writing to such a disk in this format, any physical block on the disk may be chosen for allocation of new or updated files. Since this is the basic format, practically any operating system or file system driver claiming support for UDF should be able to read this format.
The virtual CD-ROM drive cannot be removed by reformatting because it is presented to the host system as a physical device attached to a USB hub; [3] the official U3 Launchpad Removal Software was available on the U3 website and disabled the virtual CD drive device, leaving only the USB mass storage device active on the U3 USB hub controller ...
An example of a USB flash drive that supported write protection via a switch is the Transcend JetFlash series. Secure Digital (SD) cards have a write-protect tab on the left side. Extensively, media that, by means of design, can't operate outside from this mode: CD-R, DVD-R, Vinyl records, etc.
The Gutmann method is an algorithm for securely erasing the contents of computer hard disk drives, such as files.Devised by Peter Gutmann and Colin Plumb and presented in the paper Secure Deletion of Data from Magnetic and Solid-State Memory in July 1996, it involved writing a series of 35 patterns over the region to be erased.
WORM drives preceded the invention of the CD-R, DVD-R and BD-R.An example was the IBM 3363. [1] These drives typically used either a 5.1 in (13 cm) or a 12 in (30 cm) disc in a cartridge, with an ablative optical layer that could be written to only once, and were often used in places like libraries that needed to store large amounts of data.