Search results
Results from the WOW.Com Content Network
The overhand loop is a simple knot which forms a fixed loop in a rope. Made by tying an overhand knot in the bight, it can be tied anywhere along a rope (does not need any working end). The knot can be used for attaching clips, hooks, other rope, etc., but has the disadvantage that it is likely to jam tight when the rope has been pulled and the ...
A: open loop, B: closed loop, C: turn, D: round turn, and E: two round turns. In reference to knots, loop may refer to: One of the fundamental structures used to tie knots. Specifically, it is a U-form narrower than a bight. [17] A type of knot used to create a closed circle in a line. A loop is one of the fundamental structures used to tie knots.
The working end of a rope is prepared by tying a figure-eight loop, and then clipping a carabiner through that loop. The rope is then wrapped around a smooth pole, pipe, round beam or tree branch which has a diameter greater than the rope. The rope is typically wrapped 3 to 4 times around the anchor, without crossing.
The overhand knot is one of the most fundamental knots, and it forms the basis of many others, including the simple noose, overhand loop, angler's loop, reef knot, fisherman's knot, half hitch, and water knot. The overhand knot is a stopper, especially when used alone, and hence it is very secure, to the point of jamming badly. It should be ...
Below is a basic method of tying. The knot can also be made by using the rod itself to form the loop, but the tying method does not affect the performance of the resulting hitch. Begin with an overhand loop, that is, a loop in which the working part passes over the standing part:
A: An open loop. [1] B: A closed loop [2] C: Turn or single turn [3] D: Round turn [4] E: Two round turns [5] A turn is one round of rope on a pin or cleat, or one round of a coil. [6] Turns can be made around various objects, through rings, or around the standing part of the rope itself or another rope.
A slipped half hitch [1] [2] is a knot in which the weight of the load the rope carries depresses the loop sufficiently to keep it in place until the load item is placed in its location. When no longer required the free end may be pulled and draw the loop through and so release the load.
Zeppelin bend forming a loop: the four stages of the method starting with a "clover leaf" or flattened overhand knot; Red line: ends of the overhand knot, Green line: ends of the underhand. Another method of remembering this knot is to visualize a "69". To tie the knot with this method, follow the steps below: Make a "6" with one line (rope) end.