enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   Faston female terminals in three sizes, with insulation Faston male terminals in three sizes, with insulation Various single wire connectors: FASTON blade terminals (bottom), ring terminals (2 left), spade terminals (5 top), bullet terminals, male and female (2 right with blue wires)

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

4. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   Crimp tool for 0.14 mm 2 to 10 mm 2 (26–8 AWG) insulated and non-insulated ferrules. Crimping is a method of joining two or more pieces of metal or other ductile material by deforming one or both of them to hold the other. The bend or deformity is called the crimp. [1] [2] Crimping tools are used to create crimps.

5. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

6. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [ 2 ] [ 3 ] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers , battery eliminator circuits , 3D printers , and radio controlled servos .

7. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   The insulating sleeve of insulated connectors has a color that indicates the wire's cross-section area. Colors are standardized according to DIN 46245: Red for cross-section areas from 0.5 to 1 mm²; Blue for cross-section areas from 1.5 to 2.5 mm²; Yellow for cross-section areas over 4 to 6 mm²