Search results
Results from the WOW.Com Content Network
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and ...
Ford's 10-speed 10R140 TorqShift automatic transmission was now standard with the diesel and 7.3-liter gasoline engines on the F-250 and all engines on the F-350; the 6-speed was still available, but only in the F-250 with the 6.2-liter engine and even the F-350 XL DRW with the Payload Package of the same engine (though this is a rare option).
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
Honda's older transmissions such as the Hondamatic semi-automatic transmission and its successors use traditional, individual gears on parallel axes like a manual transmission, with each gear ratio engaged by a separate hydraulic clutch pack. This design is also noteworthy because it preserves engine braking by eliminating a sprag between first ...
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
In a vehicle with an automatic transmission, the torque converter connects the prime mover to the automatic gear train, which then drives the load. It is thus usually located between the engine's flexplate and the transmission. The equivalent device in a manual transmission is the mechanical clutch.