Ads
related to: applying stone veneer to drywall wall and trim molding and clips
Search results
Results from the WOW.Com Content Network
Most exterior veneer systems hang stone from a support wall by pins and anchors allowing air space between, essentially using stone as a rain screen. Anchorage systems are superior for exterior use because they permit any water that permeates the veneer to escape, while air space allows the materials of the supporting substrate wall to expand ...
Plaster veneer (American English) or plaster skim (British English) is a construction methodology for surfacing interior walls, by applying a thin layer of plaster over a substrate—typically over specially formulated gypsum board base, similar in nature to drywall.
Plasterer, a tradesperson who works with plaster, such as forming a layer of plaster on an interior wall or plaster decorative moldings on ceilings or walls. [ 10 ] Plumber , a tradesperson who specializes in installing and maintaining systems used for plumbing (drain systems), heating , drainage , fire fighting , potable (drinking) water or ...
At the place where the two edges of wallboards meet there is a seam. These seams are covered with mesh tape and then the seams and the screw heads are concealed with the drywall compound to make the wall seem as one uniform piece. The drywall plaster is a thick paste. Later this is painted or wallpapered over to hide the work.
Flexible stone veneers are made from various types of slate, schist, or marble. Flexible stone is an innovative material and such a great alternative to heavy stone and paint. It is made of natural marble chips and an acrylic aqueous dispersion. The stone can be applied on any wall: concrete, masonry, wallboard, metal, plywood, and drywall, and ...
Slipform stonemasonry is a method for making a reinforced concrete wall with stone facing in which stones and mortar are built up in courses within reusable slipforms. It is a cross between traditional mortared stone wall and a veneered stone wall. Short forms, up to 60 cm high, are placed on both sides of the wall to serve as a guide for the ...
Stone veneer is used as a protective and decorative covering for interior or exterior walls and surfaces. The veneer is typically 1 in (25.4 mm) thick and must weigh less than 15 lb per square foot (73 kg m −2) so that no additional structural supports are required. The structural wall is put up first, and thin, flat stones are mortared onto ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Ads
related to: applying stone veneer to drywall wall and trim molding and clips