Search results
Results from the WOW.Com Content Network
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
It is frequently used to implement the serial port for IBM PC compatible personal computers, where it is often connected to an RS-232 interface for modems, serial mice, printers, and similar peripherals. It was the first serial chip used in the IBM PS/2 line, which were introduced in 1987. [2] [3] [4] The part was originally made by National ...
This uses the same ATmega328 as late-model Duemilanove, but whereas the Duemilanove used an FTDI chip for USB, the Uno uses an ATmega16U2 (ATmega8U2 before rev3) programmed as a serial converter. Arduino Mega2560 [30] ATmega2560 [31] 16 MHz Mega 101.6 mm × 53.3 mm [ 4 in × 2.1 in ] USB 8U2 [28] (Rev1&2)/ 16U2 [17] (Rev3) 5 V 256 4 8 FH 54 15 16
For example, when controlling light intensity, the light may be dimmed by reducing the GPIO duty cycle. Some analog processes require an analog control voltage. In such cases, it may be feasible to connect a GPIO, which is operated as a PWM output, to an RC filter to create a simple, low cost digital-to-analog converter.
The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2010. [2] [3] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards (shields) and other circuits. [1]
JTAG (named after the Joint Test Action Group which codified it) is an industry standard for verifying designs of and testing printed circuit boards after manufacture.. JTAG implements standards for on-chip instrumentation in electronic design automation (EDA) as a complementary tool to digital simulation. [1]
This UART was introduced by Texas Instruments. TI claims that early models can run up to 1 Mbit/s, and later models in this series can run up to 3 Mbit/s. 16850 128-byte buffers. This UART can handle a maximum standard serial port speed of 921.6 kbit/s if the maximum interrupt latency is 1 millisecond. This UART was introduced by Exar Corporation.
It is sometimes called a four-wire serial bus to contrast with three-wire variants which are half duplex, and with the two-wire I²C and 1-Wire serial buses. Typical applications include interfacing microcontrollers with peripheral chips for Secure Digital cards, liquid crystal displays , analog-to-digital and digital-to-analog converters ...