enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gasket - Wikipedia

   en.wikipedia.org/wiki/Gasket

   Internal pressure acts upon the faces of the V, forcing the gasket to seal against the flange faces. Most spiral wound gasket applications will use two standard gasket thicknesses: 1/8 inch and 3/16 inch. With 1/8 inch thick gaskets, compression to a 0.100 inch thickness is recommended. For 3/16 inches, compress to a 0.13 inch thickness.

3. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   In the background of this photo is a duct flange. The duct flange normally has 3/4" bolts at 6" nominal; spacing. Duct flange angle thickness needs to be designed for duct plate tensile stresses, as flanges will bend. 5/16" or 3/8" angle thicknesses are common. See above photo of round duct elbows, transitions, and stiffeners.

4. Hard suction hose - Wikipedia

   en.wikipedia.org/wiki/Hard_suction_hose

   5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.

5. O-ring - Wikipedia

   en.wikipedia.org/wiki/O-ring

   [12] [13] [14] Because the ring is subject to the ambient pressure and the partial pressure of gases only at the seal, their gradients will be steep near the seal and shallow in the bulk (opposite to the gradient of the contact stress [15] (See Vacuum flange#KF.2FQF.) High-vacuum systems below 10 −9 Torr use copper or nickel O-rings.

6. Vacuum flange - Wikipedia

   en.wikipedia.org/wiki/Vacuum_flange

   A vacuum flange is a flange at the end of a tube used to connect vacuum chambers, tubing and vacuum pumps to each other. Vacuum flanges are used for scientific and industrial applications to allow various pieces of equipment to interact via physical connections and for vacuum maintenance, monitoring, and manipulation from outside a vacuum's chamber.

7. Slip joint - Wikipedia

   en.wikipedia.org/wiki/Slip_joint

   The slip joint includes a gasket that fits snugly on a pipe end, with a threaded nut behind the gasket, but with gasket position adjustable as needed. This pipe end fits loosely into another with a flange for the gasket to seal against, and threads for the nut to clamp the gasket to the flange.