enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bead breaker - Wikipedia

   en.wikipedia.org/wiki/Bead_breaker

   A tire bead is held in the groove by air pressure. A bead breaker is a tool used for separating tires from rims. The innermost diameter of the tire that interfaces with the rim of a wheel is called the tire bead. The bead is a thicker section of rubber, and is reinforced with braided steel cables, called the bead bundle. [1]

3. Beadlock - Wikipedia

   en.wikipedia.org/wiki/Beadlock

   A beadlock or bead lock is a mechanical device that secures the bead of a tire to the wheel of a vehicle. Tires and wheels are designed so that when the tire is inflated, the tire pressure pushes the bead of the tire against the inside of the wheel rim so that the tire stays on the wheel and the two rotate together. In situations where tire ...

4. Tire bead - Wikipedia

   en.wikipedia.org/wiki/Tire_bead

   Tire bead is the term for the edge of a tire that sits on the rim. Wheels for automobiles, bicycles, etc. are made with a small slot or groove into which the tire bead sits. When the tire is properly inflated, the air pressure within the tire keeps the bead in this groove. Reducing tire air pressure is a frequent practice among off-road vehicle ...

5. Tire changer - Wikipedia

   en.wikipedia.org/wiki/Tire_changer

   The bead loosener on the right side of a tire changer. The bead loosening system releases the tire bead from the rim of the wheel. The bead loosening system consists of an arm near the bottom right side of the tire changer. There is a shovel shaped metal piece at the end of the arm called the bead loosener shoe.

6. Radial tire - Wikipedia

   en.wikipedia.org/wiki/Radial_tire

   A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).

7. Tire uniformity - Wikipedia

   en.wikipedia.org/wiki/Tire_uniformity

   The tire is first centered, and the bead areas are lubricated to assure a smooth fitment to the measurement rims. The tire is indexed into the test station and placed on the lower chuck. The upper chuck lowers to make contact with the upper bead. The tire is inflated to the set point pressure.