Search results
Results from the WOW.Com Content Network
An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp. A clamp meter measures the vector sum of the currents flowing in all the conductors passing through the probe, which depends on the phase relationship of the currents. Only one conductor is normally ...
It merged with Sanwa Denki Manufacturing in 1965 and then became part of the SMC Group. In January 1974, Sanwa entered production and sales of transmitters for radio-controlled models and in December, became a member of the Japan Radio Control Model Industrial Association (JRM). [1] In 1975, Sanwa became a division on its own, with an office in ...
A clamp meter. Any meter will load the circuit under test to some extent. For example, a multimeter using a moving coil movement with full-scale deflection current of 50 microamps (μA), the highest sensitivity commonly available, must draw at least 50 μA from the circuit under test for the meter to reach the top end of its scale. This may ...
A negative clamp is the opposite of this—this clamp outputs a purely negative waveform from an input signal. A bias voltage between the diode and ground offsets the output voltage by that amount. For example, an input signal of peak value 5 V (V INpeak = 5 V) is applied to a positive clamp with a bias of 3 V (V BIAS = 3 V), the peak output ...
A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.
Go ahead, look at Bob Dylan.. In a post shared to X (formerly Twitter) on Nov. 19, the Nobel Prize honoree responded after a woman who apparently danced backup for him during a 1991 Grammys ...
The moving-iron meter was invented by Austrian engineer Friedrich Drexler in 1884. [5] This type of meter responds to both direct and alternating currents (as opposed to the moving-coil ammeter, which works on direct current only). The iron element consists of a moving vane attached to a pointer, and a fixed vane, surrounded by a coil.
Despite continuing demand from customers, production was stopped in 2008, reportedly due to increasing problems with suppliers of mechanical parts. [16] The last meter to leave the factory was an AVOmeter Eight Mk 7 (Serial Number 6110-610/081208/5166) which was presented in February 2010 to the winner of a competition run by the Megger company.