Search results
Results from the WOW.Com Content Network
In AmigaOS one can use the i2c.resource component [25] for AmigaOS 4.x and MorphOS 3.x or the shared library i2c.library by Wilhelm Noeker for older systems. Arduino developers can use the "Wire" library. CircuitPython and MicroPython developers can use the busio.I2C or machine.I2C classes respectively.
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
The SMBus clock is defined from 10 to 100 kHz while I²C can be 0–100 kHz, 0–400 kHz, 0–1 MHz and 0–3.4 MHz, depending on the mode. This means that an I²C bus running at less than 10 kHz will not be SMBus compliant since the SMBus devices may time out. Many SMBus devices will however support lower frequencies.
I3C targets which do not support HDR may then ignore bus traffic until they see a specific "HDR exit" sequence which informs them it is time to listen to the bus again. (One of the I2C Common Command Codes lets the controller ask a target which HDR modes it supports. This is an 8-bit mask, allowing additional HDR modes to be added in future.)
This was true as of 2000. Since then, CAN has been included, the chipset for J1939 has been clocked faster [clarification needed], and 16-bit addresses (PGN) have replaced 8-bit addresses. J1939, ISO 11783 and NMEA 2000 all share the same high level protocol. SAE J1939 can be considered the replacement for the older SAE J1708 and SAE J1587 ...
The Power Management Bus (PMBus) is a variant of the System Management Bus (SMBus) which is targeted at digital management of power supplies. Like SMBus, it is a relatively slow speed two wire communications protocol based on I²C. Unlike either of those standards, it defines a substantial number of domain-specific commands rather than just ...
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
To reduce the number of pins in a package, many ICs use a serial bus to transfer data when speed is not important. Some examples of such low-cost lower-speed serial buses include RS-232, DALI, SPI, CAN bus, I²C, UNI/O, and 1-Wire. Higher-speed serial buses include USB, SATA and PCI Express.