Search results
Results from the WOW.Com Content Network
I 2 C is the basis for the ACCESS.bus, the VESA Display Data Channel (DDC) interface, the System Management Bus (SMBus), Power Management Bus (PMBus) and the Intelligent Platform Management Bus (IPMB, one of the protocols of IPMI).
The Power Management Bus (PMBus) is a variant of the System Management Bus (SMBus) which is targeted at digital management of power supplies. Like SMBus, it is a relatively slow speed two wire communications protocol based on I²C. Unlike either of those standards, it defines a substantial number of domain-specific commands rather than just ...
It carries clock, data, and instructions and is based on Philips' I²C serial bus protocol. [1] Its clock frequency range is 10 kHz to 100 kHz. (PMBus extends this to 400 kHz.) Its voltage levels and timings are more strictly defined than those of I²C, but devices belonging to the two systems are often successfully mixed on the same bus.
I3C targets which do not support HDR may then ignore bus traffic until they see a specific "HDR exit" sequence which informs them it is time to listen to the bus again. (One of the I2C Common Command Codes lets the controller ask a target which HDR modes it supports. This is an 8-bit mask, allowing additional HDR modes to be added in future.)
FPD-Link III's embedded control channel uses the I2C bus protocol between the source and destination in the first implementations (however, it is not limited to I2C). The I2C master can read and write to all the slaves on the other side of the FPD-Link III chipset, which is effectively transparent to the I2C master and slaves communications.
The Wishbone Bus is an open source hardware computer bus intended to let the parts of an integrated circuit communicate with each other. The aim is to allow the connection of differing cores to each other inside of a chip. The Wishbone Bus is used by many designs in the OpenCores project. Wishbone is intended as a "logic bus".
The most common version, called DDC2B, is based on I²C, a serial bus. Pin 12, ID1, of the VGA connector is used as the data pin of the I²C bus, and the formerly-unused pin 15 is the I²C clock. Pin 9, previously used as a mechanical key, supplies +5V DC power (up to 50mA) to power the EEPROM.
OpenADR – Open Automated Demand Response; protocol to manage electricity consuming/controlling devices; Optomux – Serial (RS-422/485) network protocol originally developed by Opto 22 in 1982. The protocol was openly documented [1] and over time used for industrial automation applications. PieP – An Open Fieldbus Protocol